|本期目录/Table of Contents|

[1]邢星,吴玉杰,张闯,等.超深水平井钻井水力参数优选[J].断块油气田,2020,27(03):381-385.[doi:10.6056/dkyqt202003022]
 XING Xing,WU Yujie,ZHANG Chuang,et al.Optimization of drilling hydraulic parameters for ultra-deep horizontal well[J].Fault-Block Oil and Gas Field,2020,27(03):381-385.[doi:10.6056/dkyqt202003022]
点击复制

超深水平井钻井水力参数优选(PDF)
分享到:

《断块油气田》[ISSN:1005-8907/CN:41-1219/TE]

卷:
27
期数:
2020年03
页码:
381-385
栏目:
钻采工艺
出版日期:
2020-05-25

文章信息/Info

Title:
Optimization of drilling hydraulic parameters for ultra-deep horizontal well
文章编号:
22
作者:
邢星1吴玉杰1张闯1荣光来1李阳洁2
1.中国石油青海油田分公司钻采工艺研究院,甘肃 敦煌 736202;2.中国石油青海油田分公司采油五厂,甘肃 敦煌 736202
Author(s):
XING Xing1 WU Yujie1 ZHANG Chuang1 RONG Guanglai1 LI Yangjie2
1.Drilling and Production Technology Research Institute, Qinghai Oilfield Company, PetroChina, Dunhuang 736202, China; 2.No.5 Oil Production Plant, Qinghai Oilfield Company, PetroChina, Dunhuang 736202, China
关键词:
超深水平井高温高压水力参数优选钻井液排量复合钻井
Keywords:
ultra-deep horizontal well high temperature and high pressure hydraulic parameter optimization drilling fluid displacement compound drilling
分类号:
TE21
DOI:
10.6056/dkyqt202003022
文献标志码:
A
摘要:
基于传热学理论和井筒流动特性,通过建立超深水平井的井筒物理模型和温度场模型,考虑螺杆钻具的工作特性,以钻头和螺杆钻具组合的最大水力能量作为优选目标,建立了水力参数优选模型,分析了温度、压力对最小携岩排量的影响,并计算了最优排量和其他水力参数。结果表明:与不考虑温度、压力影响时相比,考虑温度、压力影响时的最小携岩排量增加了1倍;最小携岩排量随着钻井液密度和塑性黏度的降低而增大,塑性黏度是其主要影响因素;不同时刻的最小携岩排量存在一临界点,在临界点上、下井段确定最小携岩排量时,应采用不同时刻对应的最小携岩排量。因此,在超深水平井复合钻井时,应充分考虑温度、压力对水力参数优选的影响,以保证井眼清洁,提高钻井效率。
Abstract:
By establishing the physical wellbore model and temperature field model, a hydraulic parameter optimization model for ultra-deep horizontal well under compound drilling condition was established based on heat transfer theory and wellbore flow characteristics, and fully considering the influence of working performance of screw drilling tool on hydraulic parameters optimization. An iterative algorithm is proposed to analyze the effects of temperature and pressure on minimum cutting carrying displacement and pressure loss. The results show that the minimum cutting carrying displacement doubled compare with the temperature and pressure not considered. The minimum cutting carrying displacement increased with the decrease of drilling fluid density and plastic viscosity, the plastic viscosity is the main factor. In different cycle time, the minimum cutting carrying displacement has a critical point. The corresponding minimum cutting carrying displacement should be selected in different time at well section of higher or lower than the critical point. So it is necessary to consider the influence of temperature and pressure on the optimization of hydraulic parameters for ultra-deep horizontal well under compound drilling condition to ensure wellbore cleaning and improve drilling efficiency.

参考文献/References:

相似文献/References:

[1]刘小刚,崔治军,陶林,等.渤海油田科学探索井井身结构优化设计[J].断块油气田,2011,18(05):663.
[2]刘小刚,陶林,王玉山,等.渤海油田高温高压井套管优化设计[J].断块油气田,2011,18(06):787.
[3]李刚,何瑞兵,范白涛,等. PDF-HSD钻井液体系在渤海科学探索井的应用[J].断块油气田,2012,19(03):373.[doi:10.6056/dkyqt201203024]
 Li Gang,He Ruibing,Fan Baitao,et al. Application of PDF-HSD drilling fluid in scientific exploitation well of Bohai Oilfield[J].Fault-Block Oil and Gas Field,2012,19(03):373.[doi:10.6056/dkyqt201203024]
[4]王健,张作伟,苏海斌,等.高温高压条件下CO2泡沫性能评价及剖面改善效果[J].断块油气田,2019,26(02):236.[doi:10.6056/dkyqt201902021]
 WANG Jian,ZHANG Zuowei,SU Haibin,et al.Performance evaluation and profile improvement effect of CO2 foam at high temperature and high pressure[J].Fault-Block Oil and Gas Field,2019,26(03):236.[doi:10.6056/dkyqt201902021]
[5]杨洋.低孔低渗气藏高温高压储层损害因素分析[J].断块油气田,2019,26(05):622.[doi:10.6056/dkyqt201905017]
 YANG Yang.Damage factors of high temperature and high pressure reservoirs in low porosity and low permeability formation[J].Fault-Block Oil and Gas Field,2019,26(03):622.[doi:10.6056/dkyqt201905017]
[6]张冠林,徐星,赵聪,等.国内外高温高压尾管悬挂器技术新进展[J].断块油气田,2020,27(01):113.[doi:10.6056/dkyqt202001023]
 ZHANG Guanlin,XU Xing,ZHAO Cong,et al.New development of high temperature and high pressure liner hanger technologyin China and abroad[J].Fault-Block Oil and Gas Field,2020,27(03):113.[doi:10.6056/dkyqt202001023]

备注/Memo

备注/Memo:
收稿日期:2019-11-30;改回日期:2020-02-12。
第一作者:邢星,男,1991年生,助理工程师,硕士,2017年毕业于中国石油大学(北京),现从事钻井工艺研究工作。E-mail:919026437@qq.com。
更新日期/Last Update: 2020-05-21