|本期目录/Table of Contents|

[1]姜颜波.聚合物增黏CO2性能研究[J].断块油气田,2020,27(04):489-492.[doi:10.6056/dkyqt202004016]
 JIANG Yanbo.Study on viscosity increasing properties of CO2 by polymer[J].Fault-Block Oil and Gas Field,2020,27(04):489-492.[doi:10.6056/dkyqt202004016]
点击复制

聚合物增黏CO2性能研究(PDF)
分享到:

《断块油气田》[ISSN:1005-8907/CN:41-1219/TE]

卷:
27
期数:
2020年04
页码:
489-492
栏目:
默认栏目
出版日期:
2020-07-25

文章信息/Info

Title:
Study on viscosity increasing properties of CO2 by polymer
作者:
姜颜波
中国石化油田勘探开发事业部,北京 100728
Author(s):
JIANG Yanbo
Oilfield Exploration and Production Department, SINOPEC, Beijing 100728, China
关键词:
二氧化碳黏度聚乙烯基乙醚聚 ̄1 ̄癸烯
Keywords:
carbon dioxide viscosity poly(ethyl vinyl ether) poly(1-decene)
分类号:
-
DOI:
10.6056/dkyqt202004016
文献标志码:
A
摘要:
针对CO2驱过程中普遍存在的CO2气窜问题,通过云点压力测量筛选出2种在CO2中具有较好溶解性的聚合物,室内实验评价了2种聚合物增黏CO2的性能,以增黏倍数为指标评价了温度、压力对聚乙烯基乙醚、聚 ̄1 ̄癸烯增黏CO2的效果。结果表明:聚乙烯基乙醚和聚 ̄1 ̄癸烯在CO2中都具有很好的溶解性,能够显著提高CO2的黏度;聚 ̄1 ̄癸烯的增黏效果好于聚乙烯基乙醚,聚合物用量越大,增黏效果越好,温度或压力升高,增黏倍数下降;聚 ̄1 ̄癸烯可以显著降低CO2的流度,且注入流速越大,流度降低幅度越大。因此,矿场应用时,要控制增黏体系的温度和压力,适当提高注入速度,防止气窜。
Abstract:
Considering the common problem of gas channeling in CO2 flooding, two polymers with good solubility in CO2 were screened out through cloud point pressure measurement. The viscosity increasing performance of the two polymers was evaluated in laboratory experiments. The viscosity increasing ratio was used as the index to evaluate the effect of temperature and pressure on thickening CO2 by poly(ethyl vinyl ether) and poly(1-decene). The results show that both poly(ethyl vinyl ether) and poly(1-decene) have good solubility in CO2 and could significantly improve the viscosity of CO2; the thickening effect of poly(1-decene) is better than that of poly(ethyl vinyl ether). The higher the polymer dosage is, the better the thickening effect is, and with the increase of temperature or pressure, the viscosity increasing ratio of CO2 decreases. The fluidity of CO2 can be significantly reduced by poly(1-decene), and the greater the injection velocity is, the greater the fluidity reduction is. It is suggested that the temperature and pressure of thickening system should be controlled and the injection speed should be increased to prevent gas channeling.

参考文献/References:

相似文献/References:

[1]田鑫,任芳祥,韩树柏,等.可动微凝胶调驱体系室内评价[J].断块油气田,2011,18(01):126.
[2]李堪运,李翠平,何玉海,等.聚合物/表面活性剂二元复合体系室内研究[J].断块油气田,2011,18(05):678.
[3]黄万书,胡永全,赵金洲.酸压拟三维压降分析模型[J].断块油气田,2009,16(01):75.
 Huang Wanshu Hu Yongquan Zhao Jinzhou.Pseudo three dimension acid fracturing pressure decline curve analysis model[J].Fault-Block Oil and Gas Field,2009,16(04):75.
[4]苏 静,范翔宇,陈 林.CO2黏度模型及求解[J].断块油气田,2009,16(05):81.
[5]伍锐东,彭江华,刘 波,等.轮古15井区含水稠油流变性实验研究[J].断块油气田,2009,16(06):62.
[6]阎 燕,李弘博.高浅1井二氧化碳气藏测试评价[J].断块油气田,2009,16(03):123.
[7]王涛,姚约东,朱黎明,等.Box-Behnken法研究二氧化碳驱油效果影响因素[J].断块油气田,2010,17(04):451.
[8]倪玲英,李成华.聚合物降黏现场测试调研分析[J].断块油气田,2008,15(01):111.
 Ni Lingying,Li Chenghua..Field investigation on polymer viscosity break test[J].Fault-Block Oil and Gas Field,2008,15(04):111.
[9]宋时权,王承斌,邓彩云,等.套管掺稀油工艺温度场的研究和应用[J].断块油气田,2008,15(06):112.
 Song Shiquan,Wang Chengbin,Deng Caiyun,et al.Research and application of temperature field for casing doping thin oil technology[J].Fault-Block Oil and Gas Field,2008,15(04):112.
[10]杨艳霞.超深层稠油HDCS开发技术研究与应用[J].断块油气田,2012,19(稠油增刊):64.[doi:10.6056/dkyqt2012z1017]
 Yang Yanxia.Research and application on HDCS development technology for super-deep heavy oil[J].Fault-Block Oil and Gas Field,2012,19(04):64.[doi:10.6056/dkyqt2012z1017]

备注/Memo

备注/Memo:
更新日期/Last Update: 2020-07-24